Cisco Linksys WAG310G, User Manual

Page: 33 / 164

Connecting the Residential Gateway
3425-00669 Rev E 13
Connecting the Residential Gateway
Make sure that you have the following package contents:

WAG310G

RJ-45 Ethernet cable

RJ-11 phone cable

Power Adapter

One analog touchtone telephone, if configuring VoIP service

Access to a PSTN connection (wall jack).
Perform the following steps to connect the WAG310G.
1 Insert a standard RJ-11 phone cable (included) into the DSL port and connect the
other end to the PSTN wall jack.
2 (Optional) Connect a PC or other Ethernet device to the LAN port using a
standard RJ-45 Ethernet cable.
3 Insert a standard RJ-11 telephone cable into the PHONE 1 (FXS) port and connect
the other end to an analog touchtone telephone.
4 (Optional) You can connect the PHONE 2 (FXS) port to a second analog
telephone or a fax machine.
Note : To prevent an invalid connection to the circuit switched Telco network, do
not connect an RJ-11 telephone cable from the PHONE 1 (or PHONE 2) port on
the WAG310G to the wall jack.
5 Connect the RJ-11 phone cable (included) to the LINE (FXO) port and connect the
other end to your telephone wall jack.
6 Connect the included power adapter to the WAG310G power port, and then
plug the power adapter into an electrical outlet. The power LED on the front
panel will light up as soon as the device powers on.
7 Power on the WAG310G.
8 Follow the instructions in your owner's manual for your PC or laptop to activate
the wireless connection.
Note : A wireless connection requires a wireless-enabled notebook or a computer
with an 802.11b/g wireless network adapter installed.