12-5
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-03
Chapter 12 Configuring IEEE 802.1x Port-Based Authentication
Understanding IEEE 802.1x Port-Based Authentication
The Termination-Action RADIUS attribute (Attribute [29]) specifies the action to take during
re-authentication. The actions are
Initialize
and
ReAuthenticate
. When the
Initialize
action is set (the
attribute value is
DEFAULT
), the 802.1x session ends, and connectivity is lost during
re-authentication. When the
ReAuthenticate
action is set (the attribute value is RADIUS-Request),
the session is not affected during re-authentication.
•
You manually re-authenticate the client by entering the
dot1x re-authenticate interface
interface-id
privileged EXEC command.
If Multidomain authentication (MDA) is enabled on a port, this flow can be used with some exceptions
that are applicable to voice authorization. For more information on MDA, see
“Multidomain
Authentication” section on page 12-11
.
Authentication Initiation and Message Exchange
During 802.1x authentication, the switch or the client can initiate authentication. If you enable
authentication on a port by using the
authentication port-control auto
or
dot1x port-control auto
interface configuration command, the switch initiates authentication when the link state changes from
down to up or periodically as long as the port remains up and unauthenticated. The switch sends an
EAP-request/identity frame to the client to request its identity. Upon receipt of the frame, the client
responds with an EAP-response/identity frame.
However, if during boot up, the client does not receive an EAP-request/identity frame from the switch,
the client can initiate authentication by sending an EAPOL-start frame, which prompts the switch to
request the client’s identity.
Note
If 802.1x authentication is not enabled or supported on the network access device, any EAPOL frames
from the client are dropped. If the client does not receive an EAP-request/identity frame after three
attempts to start authentication, the client sends frames as if the port is in the authorized state. A port in
the authorized state effectively means that the client has been successfully authenticated. For more
information, see the
“Ports in Authorized and Unauthorized States” section on page 12-9
.
When the client supplies its identity, the switch begins its role as the intermediary, passing EAP frames
between the client and the authentication server until authentication succeeds or fails. If the
authentication succeeds, the switch port becomes authorized. If the authentication fails, authentication
can be retried, the port might be assigned to a VLAN that provides limited services, or network access
is not granted. For more information, see the
“Ports in Authorized and Unauthorized States” section on
page 12-9
.
The specific exchange of EAP frames depends on the authentication method being used.
Figure 12-3
shows a message exchange initiated by the client when the client uses the One-Time-Password (OTP)
authentication method with a RADIUS server.
