10-3
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-03
Chapter 10 Configuring SDM Templates
.Displaying the SDM Templates
Setting the SDM Template
Beginning in privileged EXEC mode, follow these steps to use the SDM template to maximize feature
usage:
After the system reboots, you can use the
show sdm prefer
privileged EXEC command to verify the new
template configuration. If you enter the
show sdm prefer
command before you enter the
reload
privileged EXEC command, the
show sdm prefer
command shows the template currently in use and the
template that will become active after a reload.
.
Displaying the SDM Templates
Use the
show sdm prefer
privileged EXEC command with no parameters to display the active template.
Use the
show sdm prefer
[
default
|
dual-ipv4-and-ipv6
default | qos
] privileged EXEC command to
display the resource numbers supported by the specified template.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
sdm prefer
{
default
|
dual-ipv4-and-ipv6
default
|
qos
}
Specify the SDM template to be used on the switch:
The keywords have these meanings:
•
default
—Gives balance to all functions.
•
dual-ipv4-and-ipv6
default
—Allows the switch to be used in
dual stack environments (supporting both IPv4 and IPv6).
•
qos
—Maximizes system resources for QoS ACEs.
Use the
no sdm prefer
command to set the switch to the default
template.
The default template balances the use of system resources.
Step 3
end
Return to privileged EXEC mode.
Step 4
reload
Reload the operating system.
