5-17
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-07
Chapter 5 Configuring the Client Adapter
Setting Advanced Ad Hoc Parameters
Go to the next section to set additional parameters or click OK to return to the Profile Manager screen.
On the Profile Manager screen, click OK or Apply to save your changes.
Setting Advanced Ad Hoc Parameters
Note
You can set advanced ad hoc parameters only if your client adapter has been set to operate in an ad hoc
network. See the Network Type parameter in
Table 5-2
.
The Advanced (Ad Hoc) screen (see
Figure 5-4
) enables you to set parameters that control how the client
adapter operates within an ad hoc network. To access this screen, select the Advanced (Ad Hoc) tab
from the Properties screens.
Enable Radio Management
Support
Checking this check box enables the access point to which the client
adapter is associated to control the use of radio management (RM),
provided RM is enabled on the access point. RM is a system-wide
feature that involves multiple infrastructure nodes. The RM feature on
the access point acts on radio measurement requests from other
network devices to instruct the access point and its associated clients
to perform required radio measurements and then report them.
Default: Checked
Note
This parameter is available in Install Wizard version 1.2 or
greater and only for 350 series client adapters.
Note
Access points must use Cisco IOS Release 12.2(13)JA or
greater to enable RM. Refer to the documentation for your
access point for instructions on enabling this feature.
Table 5-4
Advanced (Infrastructure) Parameters (continued)
Parameter
Description
