10-14
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-07
Chapter 10 Troubleshooting
Error Messages
General Error Messages
This section lists general error messages that may appear at any time and are not related to authentication
attempts.
Error Message
Bad Firmware Image File (filename)
Explanation
The selected firmware file is corrupt and will not be sent to the client adapter.
Recommended Action
Select a different firmware file and try to load it.
Error Message
Card Removed at xx:xx
Explanation
The client adapter was ejected from the computer.
Recommended Action
Reinsert the client adapter if you wish to resume wireless communications.
Error Message
An error occurred while trying to make the selected profile active.
Explanation
An error occurred when you selected a profile in ACM.
Recommended Action
Check the profile’s configuration parameters in ACU or select a new profile.
Error Message
Error Reading filename
Explanation
A problem occurred while the computer was reading the firmware file from the disk.
Recommended Action
Re-copy the firmware file to a floppy disk or to your computer’s hard drive and
try to load it again or select a different firmware file and try to load it.
Table 10-4
Locating Error Messages
Error Message Category
Page Number
General
10-14
Installation
10-18
LEAP authentication
10-20
PEAP authentication
10-23
EAP-SIM authentication
10-28