SERVICE MANUAL
–
Post eVolve Smart
7 - CHARGE POINT SLAVE DEVICES
CIRCONTROL, S.A.
–
Innovació, 3
–
08232
–
Viladecavalls (Barcelona)
Tel.: +34 937 362 940
–
Fax: +34 937 362 941
30
Web: www.circontrol.com
–
E-mail:
7.3.2
WIRING CONNECTION
Do not remove
1
2
3
4
V+
V-
A
B
POWER SUPPLY
RS-485 COMMUNICATIONS
TERMINAL
SIGNAL
WIRE COLOUR
TERMINAL
SIGNAL
WIRE COLOUR
1
V+ (12V)
Red
2
A (+)
Brown
4
V- (GND) Black
3
B (-)
White
7.3.3
DEVICE CONFIGURATION PROCEDURE
•
No additional configuration is required to operate with LCD display.
7.3.4
ADDITIONAL INFORMATION
INFORMATION ON POWER UP
Display shows the following message when device is powered up:
Note.
Peripheral number is shown as hexadecimal number
DISPLAY CONTRAST
LCD display allows changing the screen contrasts manually with a screwdriver.
Look for a potentiometer at the back of the display, as shown in the following image:
-
Position of the potentiometer can be different in each display.
-
Do not modify it if the screen contrast is correct.
Firmware version
Device ID
Baud rate (bps)
Peripheral
address
