SERVICE MANUAL
–
Post eVolve Smart
10 - CHARGE POINT ADVANCED SETTINGS
CIRCONTROL, S.A.
–
Innovació, 3
–
08232
–
Viladecavalls (Barcelona)
Tel.: +34 937 362 940
–
Fax: +34 937 362 941
70
Web: www.circontrol.com
–
E-mail:
To change the Charge Point current rating, follow the steps below:
STEP
ACTION
1
Set the IP address from the Charge Point.
IP address shall be previously assigned using IPSetup.
2
Click
on “
Connect
”
button.
3
Select the desired plugs to modify the current value. By default, all plugs are
selected.
4
Set the new current value to apply on each plug.
5
Click on
“A
pply settings
”
button and wait until the process ends.
For further information please, refer to Charge Point Setup Instruction Manual
NOTE: Charge Point Setup is available for the Charge Points with two socket/outlet type
2 but, if the current is limited by plug, the maximum current supplied by the Charge Point
will be the most restrictive set by the CPS and CPM.
