CIM MDM 1000, Operator'S Manual

Page: 72 / 100

A-72 METAL DOT MATRIX REV. 04.2002
A THE MACHINE'S SETUP
OPERATORS MANUAL
A.13 CARD TEST LIST
To make a card test connect the keyboard to the
rear DIN connector and select the mode
(continous, without card, ) by means of the F5
key.
Then press the key F3 and the number of the card
test (see the list below) and press Enter.
The card test presently available for METAL DOT
MATRIX models are shown in the following table.
0 Stamp all characters
1 Stamp an "L" in each angle of the card
5 Stamp a plate with all the machine setup
6 Stamp a CIM fixed text
7 Stamp enabled logos (see the STAMPING
CONFIGURATION menu to see how to enable
the logos for stamping)
Note: with regard to the Card Tests 0, 5 and 6, the
intercharacter and interline spaces depend to
the value of the setup parameters BLOC CHAR
SPACING and BLOC LINE SPACING of the protocol
menu.
A.14 RESET OF THE MACHINE
To reset the machine in each moment press the
following key sequence:
F 10
.
REV. 05-2008