CIM MDM 1000, Operator'S Manual

Page: 38 / 100

5-38 METAL DOT MATRIX REV. 04.2002
5 HOW TO PRODUCE ONE CARD
OPERATORS MANUAL
Fig. 5.8
Fig. 5.7
5.2 SWICHING ON THE MACHINE
Connect the serial cable to the PC with the Sword
software then switch on the machine (see chapter
3 "Installation" fig. 3.2).
If the machine does not start (verify display light
and fans) controle that the power supply is
correctly setted and that the main fuse has not
opened.
When the machine is switched on after the
initialization control that the display show as in
figure 5.7.
Press the key on front panel to make a
general reset. If the machine does not start and
the display message does not change please
verify that the top cover is closed and the red
mushroom pushbutton is not pressed, then retry.
The machine will make a reset cycle and the
display will show the model of the machine, the
Fw release with the READY status (as show in fig.
5.8) (the model will be "METAL DOT MATRIX 1000"
if you have the manual version).
NOTE: IF THE DISPLAY IS TURNED ON BUT NOTHING
APPEARS ON THE SCREEN SWITCH THE MACHINE
OFF AND CALL THE TECHNICAL ASSISTANCE.
For other breackdowns please refer to the
appropriate chapter 7 "TROUBLE SHOOTING".
The machine is now ready to run. If the Software
SWORD has already been installed on the PC, the
machine can start the production immediately. If
however another Software is used it is necessary
to control the relative parameters for the
communications protocol. To do this one enables
the Machine Setup from the console (refers to
advanced chapter for details).
REV. 05-2008