CIM MDM 1000, Operator'S Manual

Page: 52 / 100

A-52 METAL DOT MATRIX REV. 04.2002
A THE MACHINE'S SETUP
OPERATORS MANUAL
Fig. A.1
A.0 SETUP PROCEDURE
The machine is configured by accessing the
setup routine and setting or modifying various
parameters which are then saved permanently in
a CMOS memory inside the machine. To access
the setup routine connect a standard PC
keyboard to the DIN connector on the rear panel
of the machine.
Please, take care that a wrong setting of the
parameters may compromise the good
functioning of the machine.
In case of necessity, please refers to chapter A.11
to see how to restore the default value for each
parameter.
In case of impossibility in restoring or modify the
parameters, please call the service.
A.1 KEYBOARD DESCRIPTION
The following list describes the function keys and
their actions.
F 10
F10: This key is used to access the
programming menu or other internal
functions of the machine. A Password
enables this command.
F 3
F3: This key enables the production of
test cards with a pre determined format.
It is done without the aid of the computer.
Type in the number between 0 and 7
which corrisponds to the card tests desired
and then press ENTER to produce the
card.The list below describes the card
tests available.
0 Stamping all characters on the drum
1 Stamping an "L" in each angle of the card
5 Stamping a plate with all the machine setup
6 Stamping a text of type 1
7 Stamping of enabled logos
ESC
ESC: If this key is pressed the current
operating cycle will be halted and the
card will be unloaded.DUP If this key is
pressed during a READY state and it is
followed by ENTER the machine will
repeat the last card made.
PAUSE: If this key is pressed the current
operating cycle is blocked. Press START
to continue.
REV. 05-2008