CIM MDM 1000, Operator'S Manual

Page: 45 / 100

6-45
METAL DOT MATRIX REV. 04.2002
MAINTENANCE 6
OPERATORS MANUAL
Fig. 6.3
Fig. 6.2
2
1
3
1
6.3 GENERAL MAINTENANCE BY THE OPERATOR
The operator should make a habit of doing
general maintenance on the Stamper so as to
ensure a correct and long lasting functioning of
the system. The operations are simple but for
maintenance inside the machine it is necessary
to call the Technical Assistance. Thus it is
absolutelyThe routine maintenance is as follows:
6.3.1 TROLLEY-TRUCK OILING
The oiling of the trolley truck should be done
every six month, if the machine works 8 hours/
day, using vaseline oil:
•
Oil the clamp's trolley g uide (1) top and
bottom moving the trolley by hand back and
forth to assure an even distribution of the oil
and to control the fluidity of the movement.
•
Oil the clamp guide (2) in the same way as
above moving the clamp by hand and
controlling for unhindered movement. In case
of friction or jamming which persists call the
Technical Assistance
•
Remove any excess oil.
•
Oil the camshaft (3).
6.3.2 PLATE LOADER OILING
•
Oil the holes of the plate loader group shown
in the figure.
Repeat this operation every 20 days or every 1500
produced plates.
Every 6 months the internal mechanical parts
should receive a general oiling. This can be done
however only by a specialised person.
When the general maintenance is finished switch
the stamper on and control that the front cover
blocks all operations. If this not the case call the
Technical Assistance because one or more safety
devices could be dammaged.
Oil with vaseline the guide of the pushers (1).
REV. 05-2008