Maintenance
4-8
Roadster & Mirage S+/HD User Manual
020-100002-04 Rev. 1 (12-2008)
5.
REMOVE THE LAMP MODULE
Firmly grasp the handle and pull the lamp module straight out of the projector.
See Figure 4.4. Discard the lamp using safe disposal/recycling practices.
6.
INSERT THE NEW LAMP MODULE
Align the base plate of the new lamp
module under both side alignment guides
(see right). Slide the module fully into the
projector in the same orientation you
removed the old lamp module. Push with
normal force until the resistance increases,
then firmly push module another ½ inch.
NOTE:
The lamp module must make
full contact
with the lamp connectors.
Increased resistance when sliding the module in indicates initial contact with
these connectors—push firmly at this point.
WARNING
Improper installation could cause a serious
meltdown inside the projector.
7.
RE-INSTALL LAMP RETAINING BAR
Position the retaining bar along the bottom edge of the lamp module, with its
ends under the alignment guides. If the bar does not fit, push the lamp module
further in. See Figure 4.5.
IMPORTANT
The tightening order of the screws is
critical for proper lamp
contact
and
alignment
.
•
Secure screw
B
until just engaged.
•
Secure screw
A
until just engaged.
•
Go back and forth between
A
and
B
to lock the bar in place with even
pressure and correctly position the lamp module.
Figure 4.4. Remove Lamp Module
