WK2 OFF-ROAD FRONT BUMPER
INSTALL INSTRUCTIONS
TABLE OF CONTENTS
REVISION B
29 AUGUST 2022
PAGE
of
30
40
G
69
ADVANCED PARKING SENSOR KIT
Install Sensors To Inner Housing
1.
Plug Harness Extension [G-H] into the Parking Sensor
Plug.
2. Install (2) Sensor Retainer Inner [C] using L for
CP188000-0061 housing and R for CP18800-0062
housing.
3. Using Supplied M3.5 (6G) x 13mm Screw, Self
Tapping [O] secure retainer into place.
NOTE: Depending on Sensor model, retainer orientation will rotate 90
degree (as shown) to ensure a sensor fits snug.
G
71
ADVANCED PARKING SENSOR KIT
Parking Sensor KIT Fitment
1.
Install Blanking Plug 20mm Dia Head [I] into the OEM
Sensor location on the Bumper Fascia (circled in red).
2. Black Sensor Stickers [J] have been provided to
change the sensors face colour if required.
NOTE: Plastic Nylon Plug [I] can be painted to match vehicle colour with
suitable paint.
G
70
ADVANCED PARKING SENSOR KIT
Parking Sensor KIT Fitment
1.
Locate both Sensor Housing Inner LH & RH [B] to the
Top Bar [A] (as shown).
2. Route the Harness Extension lead out of the housing
ensuring there is clearing for the fasteners to prevent
pinching (as shown in middle image).
3. Install the Top bar with the parking sensor housings
on the top of the ORFB using (4) M6 x 60mm Counter
Sunk Screws [K] with M6 Hex Flange Nylock [L].
4. Before tightening, align housing to the rear edge of
the ORFB [A].
5. Lightly tighten the Screws to a toque of 5 Nm
maximum.
IMPORTANT: Over tightening the Top Bar fasteners (circled red) can
cause false sensor detection.