![background image](http://html1.mh-extra.com/html/chief/wk2/wk2_install-instructions-manual_2600237037.webp)
WK2 OFF-ROAD FRONT BUMPER
INSTALL INSTRUCTIONS
TABLE OF CONTENTS
REVISION B
29 AUGUST 2022
PAGE
of
37
40
BUMPER FASCIA TRIMMING PREPERATION
The ORFB Install Instructions DOES NOT o
ff
er a comprehensive guide to every bumper style, however
the same process can be applied.
•
Remove all grilles, fog lights, and/or parking sensors and set aside before trimming.
•
Grille features could be completely removed from the bumper OR could be trimmed and reinstalled
with the Bumper Fascia depending on individual preference and bumper style.
•
Prior to trimming; mark out the area using a marker or tape.
•
IMPORTANT: mark and measure accurately from the centreline. Failure to do so will result in issues
with the install.
•
Check your measurements before starting trim!
•
Start by trimming the most prominent parts of the bumper obstructing clearance (outlined below)
then review how much additional material needs to be removed to prevent the Bumper Fascia
contacting the ORFB.
•
Test fit bumper during trimming process to check clearance to Mounts and Winch access.
•
Dress all trimmed edges using a smooth file.
Note: Dimensions shown below can be used as approximations for each variant of the Bumper Fascia.
2017+ S-Limited/Summit Bumper shown.
=
=
30-35mm
7
0-
7
5mm
1070mm
1080mm (measured on the curved bumper
Example trim line to follow bumper feature
Measure from lower bumper joint
See step x
APPENDIX
JUMP BACK TO TRIMMING