![background image](http://html1.mh-extra.com/html/chief/wk2/wk2_install-instructions-manual_2600237021.webp)
WK2 OFF-ROAD FRONT BUMPER
INSTALL INSTRUCTIONS
TABLE OF CONTENTS
REVISION B
29 AUGUST 2022
PAGE
of
21
40
43
NON WINCH BONNET STRUT
Fasten Bonnet Strut into new Position
1.
Tighten top (2) M6 OEM fasteners then slide (3) M8
Flat Washers [V] behind the bonnet strut and
between the cross bar then fasten using M6 x 40mm
Bolt [M] with M6 Extended-Locking Washers [U].
NOTE: If the vehicle horn obstructs the new position of the bonnet strut
bend the horn bracket slightly.
44
NON WINCH
Install Fairlead Cover to ORFB
1.
Align studs on Fairlead Cover [B] through slots on
ORFB [A] then fasten (4) M6 Flange Nylock Nuts [Q]
to 10Nm.
NOTE: Ensure Fairlead Cover fits relatively even before tightening.
INSTALLATION COMPLETE -- WK2 CHASSIS MOUNTS (Front) + NON WINCH
IF YOU HAVE:
• WK2 Sump Protection Plate
(Go to Step 45)
• No WK2 Sump Protection Plate
(Go to Step 46)
For additional information refer to:
http://www.chiefproducts.com.au/installation/wk2-sump-protection-plate.pdf