Cargo Floor CF 500 SL-21-112, Assembly Instructions Manual

Page: 87 / 110

Cargo Floor B.V.
P.O. Box 271
NL-7740 AG Coevorden
Phone: +31-(0)524-
593900
Fax: +31-(0)524- 593999
Blz. 71
©
2006 Cargo Floor B.V. Coevorden, Holland
Versie 01/ 04-04-2006
www.cargofloor.nl
info@cargofloor.nl
GB
IMPORTANT INSTRUCTIONS
- Avoid letting dirt get into the hydraulic system when disconnecting the connectors or when topping
up the oil tank.
- Adjust the work speed when, for example, heavy massive products are being loaded or unloaded
when using full power (see page 63), so as to avoid overloading.
- It is recommended that the maximum operational pressure not be exceeded (see page 63). It can
happen when loading and unloading wet, heavy and massive materials, for example, that the
maximum operational pressure is exceeded. It is then advisable to decrease the load slightly, for the
benefit of the system lifetime.
- Avoid loading and unloading sharp objects such as glass. Such objects cause unnecessary wear of the
seals. If the seals are worn they can easily be replaced. New seal strips are available at your system
builder. (Article code 4008006, 300 mtr)
If you want to transport such materials safely, then we advise you to use a protective roll-up cover
mechanism.
- Never exceed the maximum number of strokes per minute when using the full stroke (see page 63). A
greater number of strokes causes enormous forces in the system and chassis, and causes a lot of heat
to be generated in the hydraulic system.
- When unloading a load, start the system slowly and gently, until the load comes free of the walls, then
you can increase the speed.
- When loading and unloading pallets it is important that good, flat pallets are placed on the floor. If
this is not the case there is the possibility that the pallets won’t move. If necessary place a softwood
plank multiplex (of about 300 x 18 x 2350 mm).
- Check the join between the 2 stationary floor profiles and the moving profiles. If there is play
between these, then adjust the stationary profiles so that the join appears optimal and there is no
leakage via the sidewalls.
- Check the join between the aluminium floor profiles and the Cargo Floor-system. If there is play then
either tighten the bolts or replace them.