Canon PIXMA iP7200 Series, Manual

Page: 525 / 637

P035
Home > Overview of the Printer > Changing the Printer Settings > Changing Printer Settings from Your
Computer > Changing the Printer Operation Mode
Changing the Printer Operation Mode
If necessary, switch between various modes of printer operation.
The procedure for configuring Custom Settings is as follows:
1.
Make sure that the printer is on, and then select Custom Settings from the pop-
up menu on the Canon IJ Printer Utility
Note
If the computer is unable to communicate with the printer, a message appears because the
computer cannot access the function information that was set on the printer.
If this happens, click
Cancel to display the most recent settings specified on your computer.
2.
Complete the following settings, if necessary
Ink Drying Wait Time
You can set the length of the printer rest time until printing of the next page begins. Moving the slider
to the right increases the pause time, and moving the slider to the left decreases the time.
If the paper gets stained because the next page is ejected before the ink on the printed page dries,
increase the ink drying wait time.
Reducing the ink drying wait time speeds up printing.
Detects a printable disc in the disc tray
Detects whether a printable disc is loaded on the disc tray during disc label printing and displays a
message if a disc is not loaded.
Check this check box to print with detecting whether a printable disc is loaded.
Uncheck this check box to print without detecting whether a printable disc is loaded.
Important
If you leave this check box unchecked, the printer may print to the disc tray even if a printable
disc is not loaded on the disc tray. Therefore, you should check this check box under normal
circumstances.
If you load a printable disc that has already been printed onto the disc tray, the printer may detect
that no printable disc is loaded on the disc tray. In this case, uncheck this check box.
Prevent paper abrasion
The printer can increase the gap between the print head and the paper during high-density printing to
prevent paper abrasion.
Check this check box to prevent paper abrasion.
Align heads manually
Usually, the Print Head Alignment function of Test Print on the pop-up menu in the Canon IJ Printer
Utility is set to automatic head alignment, but you can change it to manual head alignment.
If the printing results of automatic print head alignment are not satisfactory, see "
Aligning the Print
Head Position Manually from Your Computer ," and perform manual head alignment.
Check this check box to perform the manual head alignment. Uncheck this check box to perform the
automatic head alignment.