Canon imageRUNNER ADVANCE 6075 Series, Service Manual

Page: 513 / 1406

4
4
4-192
4-192
Parts Replacement and Clearning > Fixing > Removing the Sub Thermistor1
Parts Replacement and Clearning > Fixing > Removing the Sub Thermistor1
CAUTION: Points to Note when Installing the Main Thermistor and the Sub Thermistor
2
When the harness on the Thermistor side is short, the Sub Thermistor 2 may not
be engaged with the Fixing Roller. Perform the following procedure to check the
engagement.
1) After installing the Thermistor, temporarily place the Fixing Roller.
2) While sliding the Thermistor for at least one reciprocation by rotating the
Reciprocating Cam, check that there is no gap between the Sub Thermistor 2 and
the Fixing Roller. If a gap is found, perform the following procedure.
3) Remove the Fixing Roller.
4) Arrange the harness of the Sub Thermistor 2 so as to give the harness some slack
on the Thermistor side.
5) Perform steps 1 and 2 for double check.
Fixing Roller
Harness of Sub Thermistor 2
Fixing Roller
Sub Thermistor 2
Sub Thermistor 2
Reciprocating Cam
F-4-351
Removing the Sub Thermistor1
<Preparation>
1. Pull out the Fixing Feed Unit. (Refer to "Removing the Fixing Assembly")
2. Remove the Fixing Assembly. (Refer to page 4-176)
<Procedure>
1) Remove the Harness Guide Cover.
• 1 Screw
2) Remove the Harness to free as shown in the figure.
• 5 Connectors
• Edge Saddle
• Wire Saddle
x5
F-4-352
F-4-353