Canon imageRUNNER ADVANCE 6075 Series, Service Manual

Page: 1025 / 1406

9
9
9-28
9-28
Installation > Installation > Image Position Adjustment > Left Edge Margin Adjustment (2nd side)
Installation > Installation > Image Position Adjustment > Left Edge Margin Adjustment (2nd side)
NOTE:
If you concern alignment of the Cassette Front Cover, adjust the left and right sides of
the cover as necessary.
10) Loosen the 4 screws and adjust the position of the Cassette Front Cover by referring
to the scale.
11) When moving the Cassette Button Link Unit, adjust the left side of the Cassette Front
Cover by shifting it with the same shifting amount of the unit.
Scale
Cassette Front Cover
Cassette Front Cover
Scale
Cassette Front Cover
12) Once the position of the Cassette Front Cover is confirmed, tighten the 4 screws
(which have been loosened in step 10)).
13) Print from the cassette/deck, and check that the left edge margin of the image is
within 2.5 +/- 1.5mm.
NOTE:
When a mechanical adjustment was made, be sure to execute the service mode in step
1) again.
F-9-57
■
Left Edge Margin Adjustment (2nd side)
NOTE:
By executing the margin adjustment (2nd side) for the Cassette 3, the adjustment is
applied to all source of paper.
Execute duplex printing from the Cassette 3, and check that the left edge margin is within 2.5
+/- 1.5mm.
If it is not within the range, execute adjustment by following the procedure below.
image
L1
Feeding direction
of paper
1) Adjust the image position in service mode.
• COPIER > ADJUST > FEED-ADJ > ADJ-REFE
As the value is incremented by 1, the left edge margin is increased by 0.1mm.
2) Execute duplex printing from the Cassette 3, and check that the left edge margin is within 2.5
+/- 1.5mm.
3) When the setting value was changed in step 1), write down the new numerical value in the
service label.
4) Exit from the service mode.
F-9-58