1
2
3
4
5
6
7
8
9
10
11
Back
Next
Previous
TOP
10-41
Before Using the
Machine
Document and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network
Remote UI
System Manager
Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Is the toner cartridge installed properly?
Make sure the toner cartridge is installed properly.
(See “Set Up the Machine,” in the Starter Guide.)
Is the cartridge out of toner?
Replace the toner cartridge. (See “Replacing the Toner
Cartridge,” on p. 9-10.)
Is the correct size of paper loaded in the machine?
Make sure you load paper that meets the
requirements for use. (See “Paper Requirements,” on
p. 2-7.)
Change <PAPER SETTINGS>. (See “Setting Paper Size
and Type,” on p. 2-13.)
Received faxes print blotched or unevenly.
Is <ECM RX> set to <ON>?
ECM (Error Correction Mode) should eliminate such
problems. (See “TX/RX SETTINGS,” on p. 11-11.)
However, if the telephone lines are in poor condition,
ask the sender to send faxes again.
Q
A
Q
A
Q
A
A
Q
A
Is the sender’s machine functioning properly?
Ask the sender to check that the scanning
components of the machine are clean.
Part of the documents you receive are cut off.
Are the slide guides of the paper cassette set to
the size of the paper?
Adjust the guides of the paper cassette to the size of
the paper.
Have you specified the correct paper size for the
paper cassette?
Specify the correct paper size for the paper cassette.
Is the toner low or unevenly distributed?
Redistribute the toner inside the toner cartridge. If
the problem persists, replace the toner cartridge. (See
“Replacing the Toner Cartridge,” on p. 9-10.)
Q
A
Q
A
Q
A
Q
A
