Canon Color iR C3480, Service Manual

Page: 725 / 774

Chapter 18
18-10
F-18-12
18.2.3 Making Connections (SST in use)
0014-4492
Color iR C3380G / Color iR C2880G / Color iR C3380i / Color iR C3380 / Color iR C2880i / Color iR C2880 / iR C3480 / iR C3480i / iR C3080i / iR C2550
[Requirements]
- PC to which the SST (version 3.22 or later) has been installed and the system software has been copied
- twisted-pair cross cable
10Base-T: Category 3 or 5
100Base-TX: Category 5
[Procedure]
1) Start up the PC.
2) Connect the PC to the machine with a cross cable.
3) Check the network settings of the PC.
3-1) Start the command prompt, and type in " IPCONFIG ," and press the Return key.
3-2) Check to be sure that the network settings appearing on the screen are as follows; if not, change the PC network settings:
IP address: 172.16.1.160
Subnet mask: 255.255.255.0
Default gateway: any
Do not use the following IP addresses:
- 172.16.1.0
- 172.16.1.100
- 172.16.1.255
4) Check to make sure that the Execute/Memory lamp on the control panel is off; then, turn off the main power switch.
4-1) Hold down the power switch on the control panel for 3 sec or more.
4-2) Go through the shut-down instructions appearing on the control panel screen so that the main power switch may be turned off.
4-3) Turn off the main power switch.
F-18-13
5) Set the machine to the appropriate mode:
- Normal Mode
Turn on the main power switch while holding down the keys 1 and 7.
MFP
USB
Target Selection CONTROL Export Firm Selection
iRC3380
MFP
USB
BOOT
BROWSER
DCON
MEAPCONT
SDICT
SYSTEM
LANGUAGE
RUI
iRC3380
d:
USenXXXX(US)
Y XXxxvXXXX
Y XXxxvXXXX
Y XXxxvXXXX
Y XXxxvXXXX
N XXxxvXXXX
N USenvXXXX
Y XXenvXXXX
N XXjavXXXX
Y XXenvXXXX
N XXjavXXXX
Valid drive
DriveType:1
FileSystem:FAT
TotalSize:1,001MB
FreeSpace:1,001MB
CANCEL
EXIT
O K
R e g i s t e r F i r m wa r e
E x p o r t F i r m wa r e
D e l e t e F i r m wa r e
D e l e t e B a ck u p D a t a
S y s t e m M a n a g e m e n t
S e l e c t t h e t a r g e t . C l i c k a b u t t o n t o exe c u t e .
F i l e c o py h a s b e e n c o m p l e t e d .
Series
Version
Firmware registration status
Service Support Tool DLM0 (Ver.3.22E)
IP address: 172.16.1.100
Subnet mask: 255.255.255.0
IP sddress: 172.16.1.160
Subnet mask: 255.255.255.0
Cross cable
10Base-T: category 3, 5 or later
100Base-TX: category 5 or later