Canon Color imageRUNNER C5180 Series, Service Manual

Page: 742 / 851

Chapter 19
19-97
HDCR-DSP Used to turn off display of user mode hard disk clear mode and switch clear operations.
0: Don't display and don't clear
1: Clear once with zeroes
2: Clear once with random data
3: Clear 3 times with random data (mode displayed for settings 1 to 3)
MEMO: function for HDD initialization
This is the function to clear the data on HDD completely by overwriting the 0 (null) data and
random data to file data area at the moment of deleting files logically (timing for deleting the
administrative information data) in HDD.
2
JOB-INVL Used to set job interval during interrupt.
0: Standard setting (Output next job continuously during interrupt copy job.)
1: Start output of next job after last sheet of interrupt copy job has been delivered.
2: Start output of next job after last sheet of any job has been delivered.
2
LGSW-DSP Used to select whether to display "Log display ON/OFF setting" on user mode screen.
0: Don't display "Log display ON/OFF setting"
1: Display "Log display ON/OFF setting"
2
P-CRG-LF Used to select operation performed when drum unit has reached end of service life.
0: Don't stop
1: Stop
2
PCL-COPY Used to set compatible mode for "COPIES" PCL command.
0: Perform control on each page individually, according to value of COPIES command
specified for each page. [Factory default/After RAM clear]
1: Compatible (other controller) mode (not in use)
2: Reserved
2
PRJOB-CP Setting for count pulse (on/off) at receipt print/report print.
When using account-managing device (e.g., coin vendor, non-Canon control card), it switches
over (on/off) the count pulse notice for every page at receipt print/report print.
0: disable generation of count pulse [Factory default/After RAM clear]
1: enable generation of count pulse
Reference:
use it to apply or not apply a count pulse notification to the control guard for each page
2
DPT-ID-7 Registering a department ID and inputting a 7-digit code for authentication.
Setting Values
0: As before [Factory default/After RAM clear]
1: Inputting a 7-digit code
Reference Infomation Support for Siemens
2
RUI-RJT Disconnecting the HTTP port when three authentication failures from RUI are recognized.
Setting Values
0: Invalid [Factory default/After RAM clear]
1: Valid
Reference Information Support for Siemens
2
SND-RATE Sets compression rate when compression rate in SEND is selected 'High'.
Setting values
0: Compression rate 1/16
1: Compression rate 1/20
2: Compression rate 1/24
[Factory settings and after RAM clear: 0]
2
CTM-S06 Setting password deletion from the export file of file transmission address
Settings
0: Password is not deleted from the export file
[Factory default/After RAM clear]
1: Password is deleted from the export file
2
COPIER>OPTION>USER
Specification selection related to user mode