Canon Color imageRUNNER C5180 Series, Service Manual

Page: 638 / 851

E611 Rebooting repeat error due to
SRAM failure, etc.
0000 Rebooting error when the SRAM
data has been destroyed, the job
information saved in the SRAM can
no longer be read or when
rebooting is otherwise repeated
when the power is shut off and
restored
- Clear the SRAM.
- Clear the power shutdown guaranteed jobs.
E674 FAX board communication trouble
0001 When an error in communication
between the FAX board and main
controller PCB has been detected
for the prescribed number of times
Check the FAX board and main controller PCB connections. Replace the
FAX board. Replace the main controller PCB.
0002 When an error in communication
between the FAX board and main
controller PCB has been detected
for the prescribed number of times
0004 When trouble was detected while
the modem IC was being accessed
0008 When trouble was detected while
the port IC was being accessed
000C When trouble was detected while
the modem IC and port IC were
being accessed
0010 When trouble has been detected
when the timer device was opened
Replace the main controller PCB.
0011 When trouble has been detected
when the timer device was started
up
E677 External controller trouble
0003 External controller trouble Check the cable connections. Re-install the external controller system.
When trouble was detected during
the configuration check conducted
when the external controller was
started up
0010 When the controller of another
model has been connected
Connect to the controller which supports this unit. Re-install the external
controller system.
0080 When trouble has occurred in
communication with the printer
after the external controller started
up normally
Check the cable connections. Re-install the external controller system.
E710 IPC initializing error
0001 When the ready status fails to be
established within 3 sec. after the
IPC chip started up
Check the cable connections.
E711 IPC communication error
0001 When error occurrence was set 4 or
more times in the error register of
the IPC chip within 1.5 sec.
Check the cable connections. Replace the ADF controller PCB. Replace the
reader controller PCB.
E712 ADF/reader communication error
Displayed
code Detection timing Remedial action