Canon Color imageRUNNER C5180 Series, Service Manual

Page: 735 / 851

Chapter 19
19-90
FXLP1-SW Loop control OFF (normal speed)
Sets loop control OFF when normal speed is being used.
Set ‘1’ when image fault ‘the center of the image scraped‘ and/or ‘the rear end of the paper scraped’
occurs.
Setting values
0: Loop control ON
1: Loop control OFF
[Factory settings and after RAM clear: 1]
2
FX-SPD3 Speed change (OHP, glossy paper)
Changes TBF speed for OHP and glossy paper.
Setting range: -5 to 5
[Factory settings and after RAM clear: 1] 2
FX-LOOP1 TBF loop control and trailing edge OFF timing (normal speed)
Changes the timing of TBF loop control and trailing edge OFF, when normal speed is being used.
Setting range: -5 to 5
[Factory settings and after RAM clear: 1] 2
FX-LOOP2 TBF loop control and trailing edge OFF timing (half speed)
Changes the timing of TBF loop control and trailing edge OFF, when half speed is being used.
Set ‘1’ when the image fault ‘the center of the image scraped’ and/or ‘the rear end of the paper
scraped’ occurs at half-speed printing.
Setting range: -5 to 5
[Factory settings and after RAM clear: 1]
2
FX-LOOP3 TBF loop control and trailing edge OFF timing (OHP, glossy paper)
Changes the timing of TBF loop control and trailing edge OFF, when OHP or glossy paper is being
used.
Setting range: -5 to 5
[Factory settings and after RAM clear: 1]
2
FXLP2-SW Loop control OFF (half speed)
Sets loop control OFF when half speed is being used.
Setting values
0: Loop control ON
1: Loop control OFF
[Factory settings and after RAM clear: 1]
2
FXLP3-SW Loop control OFF (OHP, glossy paper)
Sets loop control OFF when OHP or glossy paper is being used.
Setting values
0: Loop control ON
1: Loop control OFF
[Factory settings and after RAM clear: 1]
2
FX-U-STB Changes fixer belt standby temperature adjustment.
Setting values
0: default
1: -5 deg C
2: -10 deg C
3: -15 deg C
4: -20 deg C
[Factory settings and after RAM clear: 1]
2
FX-L-STB Changes pressure belt standby temperature adjustment.
Setting values
0: default
1: -5 deg C
2: -10 deg C
3: -15 deg C
4: -20 deg C
[Factory settings and after RAM clear: 1]
2
COPIER>OPTION>BODY