Canon 1730, Service Manual

Page: 291 / 358

8
8
8-42
8-42
Service Mode > Details of Service Mode > #COUNTER > Counters
Service Mode > Details of Service Mode > #COUNTER > Counters
#ACC
■ Configuration
The table below gives summary description of the accessories available.
Item1 Item2 Explanation
#ACC CARD Card reader installation setting
Enter a card number to use.
(0 to 9999. One hundred cards are registered with the department ID beginning
from the input card number in sequence.)
*1:1,000 cards if option ROM is mounted.
When a card number is entered, the following kinds of management information
are initialized:
- Card name (department ID), beginning from the input card number.
- Password associated with the card
CC-SPSW Control card I/F support setting
Set whether to support the control card I/F (CC-V) or not.
0: Do not support.
1: Support.
COIN Coin vendor change
Set the control card set display appearing on the operator station for vendor
use.
0: Control card use
1: Coin vendor use
CONTROL Set the PDL printer output control where the control card I/F (CC-V) is
supported.
0: Enable printing without a card mounted.
1: Enable printing with a card mounted in position.
T-8-51
#COUNTER
■ Counters
This copier is furnished with a maintenance/supplies counter set (DRBL-1), which can be
used to gain rough measures of when to replace supplies. The counter set increments by one
on counting each sheet.
Maintenance counter list
Item Counter Explanation
TOTAL (Total counter) SERVICE1 Service total counter 1
SERVICE2 Service total counter 2
TTL Total counter
COPY Total copy counter
PDL-PRT PDL print counter
FAX-PRT Fax print counter
MEDIA-PRT Media print counter
RPT-PRT Report print counter
2-SIDE Double-sided copy/print counter
SCAN Scan counter
PICK-UP (Paper pickup counter) C1 Cassette 1 jam counter
C2 Cassette 2 jam counter
C3 Cassette 3 jam counter
C4 Cassette 4 jam counter
MF Manual feed tray pickup total counter
2-SIDE Double-sided paper pickup total counter
FEEDER (Feeder related counters) FEED Feeder pickup total counter
DFOP-CNT ADF open/close hinge counter
SORTER (Finisher related counters) SORT Finisher sort path counter
SADDLE Finisher saddle operation counter
SDL-STPL Finisher saddle staple operation counter
JAM (Jam counters) TTL Unit total jam count
FEEDER Feeder total jam count
SORTER Finisher total jam count
2-SIDE Duplex unit jam counter
MF Manual feed tray jam counter
C1 Cassette 1 jam counter
C2 Cassette 2 jam counter
C3 Cassette 3 jam counter
C4 Cassette 4 jam counter
MISC (Other required counter) WST-TNR Waste toner counter
T-8-52