Canon 1730, Service Manual

Page: 283 / 358

8
8
8-34
8-34
Service Mode > Details of Service Mode > #PRINT > List of Functions
Service Mode > Details of Service Mode > #PRINT > List of Functions
fixed toner on paper to be fused and adhered to drum, selecting "Yes" will clean the drum by
forming a black band on the drum surface during the reverse rotation which is performed after
printing on 50 sheets.
CAUTION:
Implementation of this mode could result in a drum life falling short of its life expectancy.
Detailed Discussions of Bit 3
Select whether to enable or disable post-rotation reduction mode. Selecting "Enable" will
reduce the noise caused by the polygon motor by stopping the motor immediately after post-
rotation.
Detailed Discussions of Bit 4
Select whether to enable or disable flicker reduction mode. Select "Enable" and enter a count
to modify fusing temperature control to cancel fluorescent flicking during printing.
CAUTION:
Implementation of this mode would degrade the throughput.
● SSSW-SW15
List of Functions
Bit Function 1 0
0 not used - -
1 Interruption of staple job when there is no stapleInterrupted Printing continued
2 not used - -
3 not used - -
4 not used - -
5 not used - -
6 not used - -
7 not used - -
Detailed Discussions of Bit 1
The operation when there is no staple during staple job processing can be set.
■ List of Functions
● 053: Margin adjustment at the leading edge of the copy
Adjust the margin at the leading edge of the copy. Increasing the value makes the margin at
the leading edge larger.
T-8-40
● 054: Margin adjustment at the trailing edge of the copy
Adjust the margin at the trailing edge of the copy. Increasing the value makes the margin at
the trailing edge larger.
● 055: Margin adjustment at the right edge of the copy
Adjust the margin at the right edge of the copy. Increasing the value makes the margin at the
right edge larger.
● 056: Margin adjustment at the left edge of the copy
Adjust the margin at the left edge of the copy. Increasing the value makes the margin at the
left edge larger.
● 058: Adjustment of the registration loop volume (Manual feed tray)
If there is a registration loop noise and abrasion while feeding the paper from the manual feed
tray, registration loop noise and abrasion could be reduced by adjusting the volume of the
registration loop. By making the value larger, loop volume will become bigger.
● 059: Adjustment of the registration loop volume. (Cassette)
If there is a registration loop noise and abrasion while feeding the paper from the cassette,
registration loop noise and abrasion could be reduced by adjusting the volume of the
registration loop. By making the value larger, loop volume will become bigger.
● 061:Adjustment of the registration loop volume. (Duplex unit)
If there is a registration loop noise and abrasion while feeding the paper from the duplex
unit, registration loop noise and abrasion could be reduced by adjusting the volume of the
registration loop. By making the value larger, loop volume will become bigger.
● 062:Temperature adjustment UP/DOWN mode. (For plain paper)
The temperature adjustment offset relative to the target fixing temperature of plain paper can
be changed in steps of 3˚C. Use this parameter when the fixing performance is low or when it
is necessary to prevent the paper from slipping or being curled.
Plain paper: Plain paper mode, thin paper mode, S thin paper mode, OHP mode
0 - 2: +15˚C
3 - 11: +12 to -15˚C (in steps of 3˚C)
12- 14: -15˚C