Canon 1730, Service Manual

Page: 252 / 358

8
8
8-3
8-3
Service Mode > Outline > Setting of Bit Switch > Outline
Service Mode > Outline > Setting of Bit Switch > Outline
Using the Mode
#SSSW
#NUMERIC
#NUMERIC
2) Selecting a Menu Item
Select the Menu item using the
[left arrow]/[right arrow] on the
touch panel.
3) Press [OK].
5) Registering/Setting Data
Enter data using the keypad,
and then press [OK].
6) Press the [Stop]/[Additional
functions]/[Reset] key to end
the service mode.
#NUMERIC
#NUMERIC
0 0 1
0 0 1
0 0 2
0 0 2
0
0
10
4) Selecting a Prarameter
Select the Prarameter using the
[left arrow]/[right arrow].
1) Selecting Service Mode
#SSSW
3) Selecting a Menu Item
Press [OK].
2) Press [OK] on the
touch panel.
5) Registering/Setting Data
Enter data using the keypad,
and then press [OK].
6) Press the [Stop]/[Additional
functions]/[Reset] key to end
the service mode.
0 3 3
4) Selecting a Bit Switch
Select the bit using the
[left arrow]/[right arrow] on
the touch panel.
#SSSW
#SSSW
000000000
000000000
<Operation at the time of Bit SW> <Operation at the time of Parameter>
0 3 3
#SSSW
000000000
0 3 3
#SSSW
000000001
1) Selecting Service Mode
F-8-1
Setting of Bit Switch
■ Outline
Bit Switch Composition
The items registered and set by each of these switches comprise 8-bit switches. The figure
below shows which numbers are assigned to which bits. Each bit has a value of either 0 or 1.
001
#SSSW
0 0 0 0 0 0 0 0
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
CAUTION:
Do not change service data identified as "not used"; they are set as initial settings.
F-8-2