Campbell LoggerNet, Instruction Manual

Page: 428 / 580

Section 10. Utilities Installed with LoggerNet
10-22
Remove Marks – A new file is created when a remove mark is found in the
data file (TOB3 only).
File Marks – A new file is created when a file mark is found in the data files
(TOB3 and TOB2 only).
Discontinuity – A new file is created when missing records are encountered
(see Check section above). The How Many? can be used so that small gaps do
not start a new file. The file will be baled only if the entered number of records
(or more) are missing.
Bale Info
Use to specify the Start Time and Interval and start time for baling based on
time.
10.5 Toa_to_tob1
This utility is used to convert TOA5 (ASCII Table Data) files to TOB1 (Binary
Table Data) format. By default, it is located in C:\Program
Files\Campbellsci\LoggerNet.
The utility is executed from a DOS command prompt as follows:
toa_to_tob1 input_filename output_filename
where input_filename is the name of the TOA5 data file
and output_filename is the name of the TOB1 file after conversion.
Note that if the utility does not reside in the same directory as the data files, the
entire directory paths must be used. Also note that the utility will overwrite
any existing file with the same name as
output_filename . So, use caution in
specifying the output_filename .