Chapter 5: Generic Installation Procedures
General Notes Concerning All Installation
Procedures
phn-3962 004v000
Page 5-2
General Notes Concerning All Installation
Procedures
Since the PTP 820C architecture is of a Dual Core nature, each dual core configuration can be
considered as single core configuration hardware ready for its dual core counterpart. Therefore,
you must follow the same procedure for
2+0 SP
installation, if you want to install a
1+0 SP HW
ready for 2+0 SP
.
One of the major benefits of the PTP 820C and the dual core architecture is that upgrading can be
done remotely by uploading the correct software license.
Before starting an installation, use a leveler to make sure that the poles are 100% vertical. You
need to check both sides of each pole at 90 degrees separation. This is a critical step in any link but
most important when installing MIMO or XPIC
Note
Do not remove the transparent pressure windows located on the antenna
interfaces.
Figure 13 Transparent Pressure Windows.
