Chapter 6: Installation Procedures per Configuration Type
MultiCore 2+2 HSB Single Polarization Direct
Mount
phn-3962 004v000
Page 6-33
Procedure
121B
1 Adjust the twist on the Splitter Kit. Perform one of the following steps, according to the
required polarization (horizontal or vertical).
For horizontal polarization, locate the holes
above and below the letter “H” on the pins
and fasten the two screws.
For vertical polarization, locate the holes
above and below the letter “V” on the pins
and fasten the two screws.
122B
2 Mount the Splitter Kit on the antenna using four M8 screws and washers and tighten the
screws.