T-Modell - 04/05 - Ausgabe 08/04 - 201804286 - BUE-0006-04EN
177
13
Wheels and Tyres
13.5.2
Tightening Torque
Fig. 184 Wheel bolts with on-board tool set
1
On-board tool set for steel wheel rim
2
Wheel bolt steel wheel rim
3
Wheel bolt alloy wheel rim
4
On-board tool set for alloy wheel rim
13.5.3
Changing the Wheel
³
Park the vehicle on as even and stable a
surface as possible.
³
Go into first gear. In the case of automatic
transmission, change gear to "P" position.
³
Apply the handbrake.
³
Place chocks or other appropriate objects
beneath the vehicle to secure it (Fig. 185).
Fig. 185 Securing vehicle
³
Remove the spare wheel from the spare wheel support.
³
If the ground is soft, place a stable support such as a wooden board beneath the vehicle jack.
³
Position the vehicle jack at the designated mounting points.
³
Turn the wheel bolts several times to loosen them, but do not remove them!
³
Lift the vehicle until the wheel has been lifted 2 to 3 cm above the ground.
³
Remove the wheel bolts and take off the wheel.
³
Place the spare wheel on the wheel hub and adjust.
³
Screw in the wheel bolts and slightly tighten them cross-wise.
³
Crank down the vehicle jack and remove it.
³
Using the wheelbrace, tighten the wheel bolts evenly (see the torque table in the section 13.5.2).
Type of
vehicle
Wheel rim
Tightening
torque
Fiat
Steel wheel rim 15" 160 Nm
Steel wheel rim 16" 180 Nm
Alloy wheel rim
130 Nm
Mercedes-
Benz
Steel wheel rim
180 Nm
Alloy wheel rim
180 Nm
Renault
Steel wheel rim
150 Nm
Alloy wheel rim
160 Nm
V
The footplate must be levelly po-
sitioned on the ground.
V
Do not tilt the vehicle jack.
V
You should have a useable spare wheel available at all times. For this reason the
wheel you have replaced should be repaired immediately.
V
Take note of the general instructions in this chapter.
Summary of Contents for T-585
