Burstner T-585, Instruction Manual

Page: 131 / 236

T-Modell - 04/05 - Ausgabe 08/04 - 201804286 - BUE-0006-04EN
131
9
Appliances
Gas operation
If the 230 V power supply is disconnected and the vehicle’s engine is not running the "AES" selects
the gas supply. When selecting gas operation the ignition fuse is opened automatically so gas can
get into the burner. At the same time the electronic ignition is activated. If the gas flame is extin-
guished, e. g. by blast of wind, the ignition is activated immediately and re-ignites the gas. When the
gas operation is faulty, the "GAS" indicator lamp (Fig. 126,4) flashes red.
Change-over between energy sources
When changing over between the different power sources there are forced delays built in the "AES".
This means, that after a change-over to a new energy source the refrigerator can not be operated
immediately. When changing over from 12 V operation to gas operation, a 15-minute delay is built
in the AES. This prevents a change-over to gas operation when the vehicle is stopped briefly and
the engine is switched off (e. g. stop to fill tank).
Refrigerating temperature control
When turned on the first time the refrigerator automatically selects the middle thermostat position.
This position can be adjusted manually by using the control knob (Fig. 126,6). The indicator lamps
(Fig. 126,5) show the selected thermostat position. The refrigerating temperature for the three types
of energy is set with the control knob. It takes a few hours till the refrigerator reaches its normal op-
erating temperature. When changing over the operation mode the thermostat setting will be main-
tained. The refrigerating temperature is retained regardless of the type of power being used.
Operation
Turning on:
³
Open the regulator tap on the gas bottle and the gas isolator tap "Refrigerator".
³
Select the energy type with the energy selector switch (Fig. 126,3). The respective indicator
lamp (Fig. 126,4) lights up green.
³
Adjust refrigerating temperature with the control knob (Fig. 126,6). The indicator lamps
(Fig. 126,5) show the selected thermostat position.
When the gas operation is faulty, the "GAS" indicator lamp (Fig. 126,4) flashes red.
Turning off:
³
Turn the energy selector switch (Fig. 126,3) to " ". No indicator lamp (Fig. 126,4) is lit.
³
Close the regulator tap on the gas bottle and the gas isolator tap "Refrigerator".
V
Open the regulator tap on the gas bottle and the gas isolator tap "Refrigerator".
V
Open flames are prohibited at petrol stations. If the stop takes longer than 15 min-
utes, the refrigerator has to be turned off at the energy selector switch (Fig. 126,3).
V
Further information can be obtained from the separate instruction manual "Refrigera-
tor".