Burkert 8756, Operating Instructions Manual

Page: 47 / 88

Type 8756
Commissioning
english 47
If the inserted memory card is empty, then the product
loads its own data on the memory card. Possible prob-
lems related to the memory card are given in chapter:
Miscellaneous problems [
}
73]
▶ If the memory card is defective or lost, then buy a new
memory card from your Bürkert sales office.
Product variant büS /CANopen: Choose between CANopen
communication and büS communication. Refer to chapter:
Set
the CANopen communication or the büS communication
[
} 55]
Run the Autotune function. Refer to chapter: Optimise the
closed-loop control parameters (MFC) [ } 59]
The product operates normally.
7.4 Commissioning procedure (MFC
with proportional valve)
The operation of the product is tested at the factory with
fluid. Residual fluid can remain in the fluidic parts of the
product.
No zero adjustment is needed.
Pressurise the pipes with operating fluid.
Make sure that the proportional valve is completely open.
Flush the pipes with operating fluid.
Vent the pipes completely.
Connect the product to the Bürkert Communicator software.
Refer to chapter
Connect the product to the Bürkert Commu-
nicator software [ } 53]
Flush bubbles from the pipes as described in chapter: Flush
bubbles from the pipe (MFC with proportional valve) [
}
51]
Wire the product again as described in chapter Electrical con-
nection [
}
37] .
Energise the product.
If product-specific data is stored on the inserted memory
card, then the product adopts the data. To get a list of
the stored data at product delivery, refer to the Help for
the Initiation file that can be downloaded from
country.burkert.com .
If the inserted memory card is empty, then the product
loads its own data on the memory card. Possible prob-
lems related to the memory card are given in chapter:
Miscellaneous problems [
}
73]
▶ If the memory card is defective or lost, then buy a new
memory card from your Bürkert sales office.
Product variant büS /CANopen: Choose between CANopen
communication and büS communication. Refer to chapter:
Set
the CANopen communication or the büS communication
[
}
55]
Run the Autotune function. Refer to chapter: Optimise the
closed-loop control parameters (MFC) [
}
59]
The product operates normally.