6
39
It is recommended that a carbon monoxide detector be installed in
the living area near a location where the vehicle may be garaged.
Since there are many different makes and models of vehicles, visit
our website, www.bulldogsecurity.com.
Read this manual thoroughly before starting the installation.
TACH/TACHLESS OPERATION
In most cases the decision to go with tachless mode will save time during the
installation. If your vehicle is hard-starting then you should use tach mode.
MAKE SURE YOU PLACE THE WARNING STICKER UNDER YOUR HOOD.
BEFORE YOU BEGIN
This remote system is designed to start your vehicle by sending a command
signal from the remote transmitter. It is important that your installation be done
in a well-ventilated area.
It is the responsibility of the owner to ensure
that the remote system is not used to start the vehicle in an undesired
location.
OPERATION
Note:
The Remote Start Unit will not start the vehicle if any one of the
following conditions exists:
1. The hood is opened.
2. The brake pedal is pressed.
3. Move the optional remote start enable toggle switch to OFF position.
(If installed)
4. The gear selector is in any gear other then PARK or NEUTRAL.
B. TO OPERATE THE VEHICLE WHILE RUNNING ON THE REMOTE
START:
To operate the vehicle while the engine is running on the remote starter.
1. Insert the ignition key and turn it to ON (not the crank) position.
2. Press the brake pedal.
Note:
If the brake pedal is pressed before the key is in the ON position,
the engine will shut down.
C. PIT STOP FEATURE:
This feature allows the vehicle to remain running after the key has been
removed from the ignition. This feature is useful for occasions when you
wish to exit and lock the vehicle for short periods of time, but would like
to leave the motor running and the climate control on.
1. Before turning off the engine, press the button twice on the transmitter
and the LED indicator will flash (3) times to confirm enter.
2. Turn the ignition key to OFF position. (The engine will stay running.)
3. The engine will run until the pre-programmed time elapsed or shutdown
input is received.
D. TIMER START:
This unit can be programmed to start and run the engine every 2 or 3
hours, the engine will run for the programmed time and then
shut down.
IMPORTANT
: Timer Start should be used only in open areas, never start
and run the vehicle in on enclosed space as a garage or carport.
This feature is design for an extreme cold climate usage. The system will
auto start the vehicle every 2 or 3 hours, to prevent engine freezing and
hard to start. A MAXIMUM OF SIX CYCLES CAN OCCUR.
ENTER:
1. Press the button twice to remote start the vehicle. As
soon as the vehicle is running and the parking light have
turned on or flashing.
2. Immediately depress the
button once, within (2)
seconds
If your vehicle has an anti-theft system, you will need an additional
module, Part #791.
Congratulations, you have purchased one of the most advanced remote starter
systems ever made. Your new remote starter is a technological breakthrough
utilizing the most advanced, state of the art technology and components. The
dependability and variety of features make Bulldog Security the leader in the
industry. Enjoy your new remote starter for years to come!
TECHNICAL ASSISTANCE
Should you need help. First check our website at www.bulldogsecurity.com
or call our toll-free Tech Support Hotline at 800-878-8007.
Summary of Contents for DELUXE 200
Page 1: ......
