7
38
PRECAUTIONS
DO NOT
mount the control module until all connections have been made
and tested.
PLEASE USE CAUTION: DO NOT CUT, PROBE OR DISCONNECT THE
VEHICLES AIRBAG WIRES. THESE WIRES WILL ALMOST ALWAYS
BE INSIDE A BRIGHT YELLOW TUBE LOCATED NEAR THE STEERING
COLUMN HARNESS.
WARNING!
On vehicles with air bags or supplemental restraint systems
(SRS) you may notice a bright YELLOW or RED tube with small wires in
it marked SRS underneath the steering column near the key cylinder. DO
NOT tamper or unplug these for any reason to prevent costly damages to
your vehicle or personal injury. Tampering may cause unintended deployment
of the air bags.
!
DO NOT
leave the interior or exterior lights on for an extended period of time
as it may cause battery drain. Remove the dome light fuse from the fuse box.
NOTE:
Starter systems do not work well with a partially discharged battery.
OPERATION
J. VIBRATION/MELODY MODE:
It is useful when you are in a noisy place.The remote
control in this mode, vibrates it if your security system is
triggered.
1. Press
button first, within (5) seconds, press the
button to select the mode of vibration or melody, the
icon will displayed on the LCD screen to show the LCD remote
transceiver is on vibration mode.
2. To exit programming mode, take no action for (5) seconds. The
remote control will generate two long beeps to indicate programming
mode has been exited.
K. SCREEN LAMP ON:
Press the
button once; the LCD screen lamp will turns on for (5) seconds.
REMOTE START OPERATION:
A. TO REMOTE START THE VEHICLE:
When you want to start your vehicle,
1. Press button twice on the transmitter
2. The parking light will activate to indicate the remote start
received the signal. (A melody sounding from your Remote
LCD transceiver and icon will flashes on the LCD
screen to confirm the remote start was activated.)
3. The engine will start in approximately (5) seconds.
4. Once the engine is running, after a couple of seconds the
parking light will turn on again and climate controls will
activate and adjust the vehicles interior temperature to
your preset setting. (While the vehicle is running, the
icon and the minutes digit on the LCD screen will flash
and it will indicate count down timer based on the 5, 10,
20 or 30 minute run time set up by your installation
center.)
5. The vehicle will run for 5 to 30 minute cycle and
automatically shut down. (When the unit shuts off the
count down timer will turn off and the transmitter will play a melody.)
Activate
Remote
Start
Engine
Running
This system is designed for use with vehicles equipped with fuel-
injected, gasoline engines and automatic transmissions only.
SAFETY FIRST!
Never start your vehicle if it is indoors. A periodic safety check is recommended
to ensure that your system is in proper working order.
DO NOT
use mechanical wiring connections, such as crimp or snap together
taps.
DO NOT USE
mechanical wiring connections such as a crimp or snap-
together taps except on wires that are pre-installed from the factory. For wires
that do not have the snap connectors pre-installed from the factory, wires must
be connected using the illustrations under the Making Connections section of
this manual. Failure to properly connect the wires can result in damage to your
system or your vehicle.
DO NOT
disconnect the battery if the vehicle has an anti-theft-coded radio or
is equipped with an airbag. Doing so may cause a warning light to be displayed
and may require a trip to the dealer to be corrected.
Summary of Contents for DELUXE 200
Page 1: ......
