Bulldog Security DELUXE 200, Installation And Owner'S Manual

Page: 9 / 22

‘ ‘
‘ ‘
9 36
OPERATION
B.LOCK DOORS:
1. Press button on the transmitter.
2. The horn will chirp once and parking light will flash once
indicating that the vehicle’s door is locking.
SILENT LOCKING / UNLOCKING DOORS: Press the transmitter
and buttons at the same time will Lock or Unlock the vehicle’s
doors, No chirp sound will be heard, Lock or Unlock confirmation
will be through the vehicles parking lights only.
C. UNLOCK DOORS:
1. Press button on the transmitter.
2. The horn will chirp twice and parking light flash twice to
indicating that the vehicle’s door is unlocking and the dome
light will turn on for 30 seconds.
PATHWAY ILLUMINATION : This feature turns the parking
light “ON” for 30 seconds upon a unlock signal and for 10 seconds
upon the lock signal.
TWO STEPS DOOR UNLOCK : This feature will independently
unlock the driver’s door only. Pushing the button a second
time within 3 seconds will unlock the other doors.
A. REMOTE TRANSMITTER OPERATION:
Transmitter
Button System Function or Feature Remark
Lock Doors
- Car Locator Press twice within 3 sec.
(3 sec.) Panic Press and hold for 3 sec.
+ Silent Locking / Unlocking Ign. in the "Off" position.
Unlock Doors
- Two Steps Door Unlock Press twice within 3 sec.
(2 sec.) Trunk Release (Channel 3) Press and hold for 2 sec.
- Activate or Turn Off The Remote Start Press twice within 3 sec.
- Melody / Vibration Mode
LCD Screen Lamp Turns on for 5 Seconds
3. Separate the vehicle wire(s) as shown. Make the separation large enough
to fit the other wire through.
2. Strip back one inch of insulation on the wire you need to connect to.
One Inch of Bare Wire One Inch of Bare Wire
4. Insert the wire(s) from the starter through the hole as shown. If two or more
wires are inserted, wrap them in opposite directions.
5. Wrap the wire around one side then the other and finally around itself as
shown.
1 1
2 2
3 3
6. Use electrical tape to wrap. Be sure to cover the wire about two inches on
either side of the connection. First pull the wire that you have just connected
along side the wire you connected to, tape and wire tie them together. Use
this method for all connections.
CAUTION: All wires must be wrapped with tape and wire tied.
Wire Wire TTie ie
Electrical Electrical TTape ape
MAKING END TO END CONNECTIONS
Use this method ONLY when connecting two separate wires end
to end.
MAKING WIRING CONNECTIONS