Bulldog Security DELUXE 200, Installation And Owner'S Manual

Page: 5 / 22

‘ ‘
‘ ‘
5
REQUIRED TOOLS
40
Unless your remote starter includes a Bonus Installation Kit you will need the
following items: a sharp knife, electrical tape and a computer-friendly test light.
A 5/16 inch drill bit may be needed to install the hood pin switch. If the bottom
of your dash on the driver’s side will come off, you must remove it. If this is the
case a screwdriver or a wrench may be needed.
INSTALLATION CHECK LIST
INSTALLATION CHECK LIST
• Read the manual.
• Watch the video.
• Verify that you have all the parts listed in the manual.
• Obtain the correct wiring chart for you vehicle.
• Identify air bag and SRS wires before starting your installation.
Check to see if additional parts are needed. These items are identified
in your manual and the wiring chart diagram for your vehicle.
Possible items to review:
• Anti-theft By-pass • Relays • Diodes
• Transponder Key • EZ-Bus • Resistors
Check for optional parts to make your installation easier:
• T-harness • EZ-Bus
3.Rapidly depresses the button. The parking light will
flash (3) times. The siren or horn chirps (3) times. The vehicle is now
programmed to start every 2 or 3 hours.
4. Press the brake pedal to stop the vehicle running.
Exit the timer start:
Timer start can be exited manually as follows:
1.Make sure the remote start system is not operating the engine.
2.Turn the ignition on. The LED and parking light will flash (4) times.
The horn chirps (4) times.
Or
1.Press the button twice to remote start the vehicle. As soon as the
vehicle is running and the parking light have turned on or flashing.
2.Immediately depress the button then press and hold the button
for (2) seconds. The parking light will flash (4) times. The siren or
horn chirps (4) times. The vehicle is no longer programmed to start
automatically.
E. TO TURN OFF THE REMOTE START:
When the engine is running (by remote start), if you want to
stop it,
1.Press button twice on the remote transmitter under
remote start mode.
2.Move the optional remote start enable toggle switch to
OFF position. (If installed)
3.Press the brake pedal.
The vehicle will shut down and turn off the parking light to indicate engine
stopped.
F. SHUT-DOWN INPUT FOR REMOTE STARTER:
If any of the following conditions exist while the system is operating, the
engine will not start or will shut down immediately:
1. The hood is opened.
2. The brake pedal is pressed.
3. Engine is over-revved. (“Tachometer checking type” only)
4. The pre-programmed run time (5 /10 / 20 / 30 minutes) has elapsed.
5. Press button twice on the remote transmitter under remote start
mode.
6.Move the optional remote start enable toggle switch to OFF position.
(If installed)
7.The vehicle refused to start running after (3) unsuccessful attempts.
OPERATION
REMOTE START OPERATION ..........................................................38-41
A. To Remote Start Your Vehicle .....................................................38-39
B. To Operate Your Vehicle While Running on the Remote Start................39
C. Pit Stop Feature ............................................................................39
D. Timer Start..............................................................................39-40
E. To Turn Off the Remote Start ..........................................................40
F. Shut Down Input for Remote Starter.................................................40
G. Disabling the Remote Start System..................................................41
LCD REMOTE TRANCEIVER ..........................................................41
REMOTE LCD ICON DESCRIPTIONS .............................................42
WARRANTY .................................................................................43
TABLE OF CONTENTS