Bulldog Security DELUXE 200, Installation And Owner'S Manual

Page: 17 / 22

‘ ‘
‘ ‘
17 28
PROGRAMMING
START TIMER PROGRAMMING: (TEST and ADJUST)
1. Press the button twice on the transmitter to start the vehicle.
2. If everything goes well: Wait for 15 seconds:
a. If the engine is still running.
I. Press the button twice on the transmitter to stop the engine
from running. You have completed this programming
successfully.
II. Press button on the transmitter to exit the program mode. There
will be (3) long chirps and (3) parking light flashes for confirmation.
b. If the engine shut down after the vehicle was started.
I. Press the button twice on the transmitter to remotely turn off
the ignition.
II. Press button on the transmitter to set “Check Level” to “LOW”
position. (2) LED flashes, (2) chirps to confirm this setting
III. Repeat the step1 – 2.
3. If the crank time is too long, (Engine already successfully running, while
starter remains engaged):
a. Press the button twice on the transmitter to stop the engine from
running.
b. Press button on the transmitter to set proper “Start Timer”. The
chirp and LED pause will confirm that you have entered this mode.
(Decrease “Start Timer” as necessary.)
c. Repeat the step1 – 4.
4. If the crank time is too short, (Engine is not running, starter did not stay
engaged long enough):
a. Press the button twice on the transmitter to stop engine running.
b. Press button on the transmitter to set proper “Start Timer”. The
chirp and LED pause will confirm this enters. (Increase “Start Timer”
is necessary.)
c. Repeat the step1 – 4.
RETURN TO FACTORY DEFAULT SETTING:
1. Turn the ignition “ON” then “OFF” (3) TIMES and stay in “OFF”
position.
2. Push the Program switch (12) times and hold in on the 12th push until
(6) chirps with a long chirp is heard then release the Program switch.
You are now in the “Return To Factory Default Setting” programming
mode.
WIRING CONNECTIONS
This wire provides an instant shutdown for
the remote start, whenever it receives
+12volts . If the brake lights switch in the
vehicle switches +12 volts to the brake light circuit,
connect this wire to the output side of the brake
switch. This will allow the remote start to shut
down if an attempt is made to operate the vehicle without
the key while running under the control of the remote start. In most vehicles,
in order to shift gear, the brake pedal must be pressed. The brake input will
in turn cause the remote start unit to shut off. (See diagram.)
2.If needed, This wire will connect to the PARK/NEUTRAL switch
in the vehicle. (See the TESTING YOUR INSTALLATION GUIDE)
IMPORTANT NOTE: Directly connect the THIN BLACK wire to
the “GROUND” when this wire is not used.
H4/3 - Brown / Red wire – (+) Positive Safety Shut Down For Brake
H4/2 - Thin Black wire – (-) Neutral Safety Switch or (-)
Remote Toggle Switch Input –
When the THIN BLACK wire is grounded, the remote start unit
is operable. When this wire is open from ground, the remote start
is disabled.
1. The optional “remote start toggle switch” can be added on to
temporarily disable the Remote Start Device, it can prevent the
vehicle from being remote started accidentally. This feature is
useful if the vehicle is being serviced or stored in an enclosed
area. To disable the remote start, move the remote start enable
toggle switch to the “OFF” position. To enable the remote start,
move the optional remote start enable toggle switch to the
“ON” position.
H4/4 - Grey wire – (-) Negative Safety Shut Down For Hood Pin
Switch
This wire provides an instant shutdown for the remote start, whenever
it is grounded. Connect the wire to the hood pin switch previously installed.
This wire must be routed through a grommet in the firewall and connected
to the hood pin switch.