Buell Ulysses 2006, Service Manual, Page: 634 / 638

7-80 2006 Buell Ulysses: Electrical
HOME
4. See Figure 7-95. Position the voltage regulator connec-
tor as it is shown, with the connector latch to the back
and above the bottom sprocket cover boss.
NOTE
Make sure that the voltage regulator connector is all the way
back against the plastic wire guard.
5. The main harness bundle needs to be pressed into place
between the front sprocket cover mounting boss and the
oil return line.
6. The vehicle speed sensor wires (3-pin grey) are routed
behind the oil breather line fitting on the cam cover
7. See Figure 7-96. At the oil pressure switch, use a cable
strap to encircle the voltage regulator wire bundle and
the oil pressure switch wire, and secure to the base of
the oil pressure switch itself.
8. Then move back and cable strap that bundle with the
cam position sensor wires. Orient the cam sensor wires
on top and the oil pressure switch wire inside of it.
9. Connect the neutral safety switch (single bullet), and the
cam position sensor (3-pin black).
10. See Figure 7-97. Using a cable strap, secure the loop the
neutral safety wire makes to the cam position connector
under the attachment clip on the connector.
Figure 7-95. Voltage Regulator Connector Latch
Figure 7-96. Cable Strap Locations
Figure 7-97. Cam Position Sensor Connector with Cable
Strap
12011
12012
12013