Buell Ulysses 2006, Service Manual, Page: 223 / 638

2006 Buell Ulysses: Chassis 2-99
HOME
ASSEMBLY
1. See Figure 2-129. Install right tail section (2) onto vehi-
cle.
a. Install fastener (1) attaching right front trunk pan to
right side tail section and tighten to 48-72 in-lbs
(5.4-8.1 Nm).
b. Install fasteners (5) attaching right rear tail section to
center tail loop and tighten to 20-22 ft-lbs (27.1-29.8
Nm).
c. Apply LOCTITE 272 (red) and install fasteners
attaching right tail section to main frame/fuel tank
assembly and tighten to 21-23 ft-lbs (28.5-31.2 Nm).
2. Install master cylinder remote reservoir. See 2.13 REAR
BRAKE MASTER CYLINDER .
3. Install shock reservoir, retainer, and fastener. Tighten to
80-88 in-lbs (9.0-9.9 Nm).
4. Connect rear brake light switch connector [121].
5. Install ECM and tighten fasteners to 36-60 in-lbs (4.0-
6.8 Nm).
1 1
WARNING
1
WARNING
Connect positive (+) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explo-
sion, which could result in death or serious injury.
(00068a)
6. Install battery by threading positive cable (red) into
threaded hole first tightening to 72-96 in-lbs (8-11 Nm).
See
1.4 BATTERY MAINTENANCE .
1 1
WARNING
1
WARNING
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
7. Install seat. See 2.45 SEAT .