Buell Ulysses 2006, Service Manual, Page: 601 / 638

2006 Buell Ulysses: Electrical 7-47
HOME
TAIL LAMP 7.13
REMOVAL/DISASSEMBLY
1. Remove seat. See 2.45 SEAT .
2. Disconnect connector [93] from tail lamp.
3. Remove fasteners securing tail lamp to center tail sec-
tion and remove tail lamp.
ASSEMBLY/INSTALLATION
1. See Figure 7-50. Install tail lamp (3) with fasteners (2) to
the center tail section (1). Tighten fasteners to 12-36 in-
lbs (1.4-4 Nm).
2. Attach the tail lamp harness connector [93].
1
WARNING
1
WARNING
Be sure that all lights and switches operate properly
before operating motorcycle. Low visibility of rider can
result in death or serious injury. (00316a)
3. Check tail lamp for proper operation. If operation fails,
reread procedure and verify that all steps were per-
formed.
a. Turn ignition key switch to ON.
b. Check for tail lamp illumination.
c. Squeeze front brake hand lever. Check for brake
lamp illumination. Release front brake hand lever.
d. Press rear brake pedal. Check for brake lamp illumi-
nation. Release rear brake pedal.
e. Turn ignition key switch to OFF.
1
WARNING
1
WARNING
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
4. Install seat. See 2.45 SEAT .
Figure 7-50. Tail Lamp Assembly
1. Center tail section
2. Nuts and washers (2)
3. Tail lamp
b1139x7x
1
3
2