Buell Ulysses 2006, Service Manual, Page: 258 / 638

3-24 2006 Buell Ulysses: Engine
HOME
22. Remove cable strap securing wire bundle to return oil
line.
23. See Figure 3-18. Disconnect electrical components:
a. Neutral switch [131].
b. Speedometer sensor [65] (remove cable strap).
c. Cam position sensor [14].
d. Positive battery cable at starter.
e. Starter solenoid [128].
f. Oil pressure switch [120].
g. Alternator connector [46].
h. Voltage regulator connector [77].
24. See 3.10 OIL LINE FITTINGS . Remove all oil lines
(including lines to oil cooler).
25. See Figure 3-17. Remove vent oil line (2).
a. Disconnect vent oil line (2) at gearcase cover.
b. Remove clamp (13) in front of starter securing vent
oil line to return oil line.
c. Disconnect vent oil line at swingarm/oil reservoir (1)
and remove. See
3.10 OIL LINE FITTINGS/
REMOVAL .
26. See Figure 3-17. Remove feed oil line (3).
a. Loosen fitting at oil pump (14).
b. Remove two p-clamps (12) from feed oil line (one on
crankcase and one on swingarm/oil reservoir.
c. Remove feed oil line (3) at oil pump (14).
d. Disconnect feed oil line at swingarm/oil reservoir
and remove. See 3.10 OIL LINE FITTINGS/
REMOVAL.
27. Remove front and rear muffler brackets.
28. See Figure 3-17. Remove return oil line (4).
a. See Figure 3-19. Remove convolute covering from
return oil line.
b. See Figure 3-17. Loosen fitting at oil pump (14).
c. Remove p-clamp (12) at swingarm/oil reservoir (1).
d. Disconnect oil return line (4) at swingarm/oil reser-
voir (1). See 3.10 OIL LINE FITTINGS/ REMOVAL.
e. Disconnect oil return line (4) at oil pump (14) and
remove.
29. Disconnect and remove oil cooler oil lines. See 3.11 OIL
COOLER .
Figure 3-19. Removing Convolute Cover From Oil Line