Buell Ulysses 2006, Service Manual, Page: 213 / 638

2006 Buell Ulysses: Chassis 2-89
HOME
BELT GUARDS 2.37
REMOVAL
1. Place a scissor jack under jacking point and raise rear
wheel off ground. For location of jacking point see
2.32
EXHAUST SYSTEM.
2. Loosen rear axle pinch fastener.
3. Loosen rear axle approximately 15 rotations to allow par-
tial tension to be removed from rear drive system.
4. See Figure 2-124. Remove rear fender/upper belt guard
(1) by removing fasteners from swingarm.
5. Remove lower belt guard (3) by removing the two fasten-
ers (4) located on the outside of the lower belt guard.
6. Once the lower belt guard has been removed, remove
the metal stone guard (5).
INSTALLATION
1. See Figure 2-124. Apply LOCTITE 272 (red) and install
rear fender/belt guard (1) to swingarm. Tighten fasteners
to 12-36 in-lbs (1-4 Nm).
2. Install stone guard and tighten fasteners to 12-36 in-lbs
(1-4 Nm).
3. Install lower belt guard (3) and tighten fasteners (4) to
12-36 in-lbs (1-4 Nm).
4. Tighten rear axle to 48-52 ft-lbs (65-70 Nm).
5. Tighten rear axle pinch fastener to 40-45 ft-lbs (54-
61 Nm).
6. Remove scissor jack from motorcycle.
Figure 2-124. Belt Guard Assembly
b1217x1x
1. Rear fender/upper belt guard
2. Rear fender/belt guard fasteners (2)
3. Lower belt guard
4. Lower belt guard fasteners (2)
5. Stone guard
2
4
1
3
5
2