Heating circuit data
11
Logamatic 4323 - Subject to technical modifications.
41
11 Heating circuit data
You may select the following heating systems:
–
None
The heating circuit function is not required. All subsequent submenu points
relating to "Heat circ. data" no longer apply.
–
Radiators or Convector
The heating curve is automatically calculated for radiators or convector
heaters, depending on the required curve.
–
Underfloor
A flatter heating curve is automatically calculated for lower design
temperatures.
–
Low end
The level of the flow temperature is a linear consequence of the outside
temperature. The resulting heating curve connects as a straight line the low
end with a second point that depends on the design temperature.
–
Constant
Use this system for controlling a swimming pool heating system or to pre-
control ventilation circuits, if the heating must always provide the same, set
flow temperature, independent of the outside temperature. You cannot install
a remote control for this heating circuit if you have selected this system.
–
Room controller
The set flow temperature is only dependent on the actual room temperature.
For this, you must install a remote control inside the room. The heating
system is switched off if the room becomes too hot.
