btsr SMART 200 TSS, Operating Manual

Page: 52 / 93

Operation
- 3.36 - SMART 200 TSS
COM TEST - Testing the Efficiency Rate over the Communications Line between the
SMART 200 TSS Terminal and Sensors
SETUP # # # #
CONFIG
# # # # TEST # COM
This function allows you to check the perfect operation of the communications line
between the SMART 200 TSS Terminal and connected Sensors.
It is advisable to run this check during the first testing phase (immediately after
installation) and each time random problems occur in the system operation, which
may have been caused by inefficient communications between the Sensor and the
Terminal (for example: Defects along the yarn which have not been signaled by the
sensors).
Press until the TEST CONFIG menu option is displayed.
Press to have access to the Test function.
Press to select the Communications Test
This screen indicates that the Communications Test is going to start
Press to begin the test.
From this moment on, the system communicates repeatedly with all connected
sensors. The running test status is signaled by the flashing red LED inside ENTER
button. If there are no communications errors detected, the display shows the
message TEST CO 000/000. If communications errors are detected, the display
shows the message TEST CO XXX/YYY, where the XXX indicates the total
number of failed attempts and YYY indicates the total number of sensors where
some problems occurred.
Press
once to leave this function, or press it twice to return to the Main Menu.
A
15