btsr SMART 200 TSS, Operating Manual

Page: 30 / 93

Operation
- 3.14 - SMART 200 TSS
Preliminary operations for using the SMART 200 TSS terminal
! Just after installation and before beginning to use the system, check that all
the connectors are plugged in properly and that TS5.. devices are turned on.
Power on the system and check that the graphic display shows sequentially, for a
few seconds, the screens shown on the left side of this page:
(BTSR Logo)
(Type of SMART system)
(Installed software version)
!
If the display is blank please refer to “Troubleshooting” chapter”.
If the ERROR RAM message appears on the screen, it means that the self
diagnostics performed at power on has detected an error in the memory of the
SMART terminal. Press to reset the error.
! The system will erase all settings entered by the user and will reload the
default values!!.
If the error persists, please refer to “Troubleshooting” chapter.
If the system displays one of the messages that you can see on the left hand side of
this page, it means that the terminal is working correctly and that it is possible to
activate one of the four options of the main menu.
If required, press to select the desired function:
>
SETUP
to run the configuration/programming of the system.
>
WORK
to load the article values into the sensors.
>
CONTROL
to enable automatic monitoring.
>
GRAPH
to read the tension of yarn detected by each sensor
! Pressing the Reset button when the system displays any of the main menu
items, the current software version (TSS (TSQ) VER. X.X) will be displayed.
System
Start