btsr SMART 200 TSS, Operating Manual, Page: 20 / 93

Operation
- 3.4 - SMART 200 TSS
TS5.. Sensor Features
The TS5.. devices are intelligent sensors able to detect, due to sophisticated control
technique, the tension applied to the yarn being controlled, signalling possible
anomalies about the tension itself.
The tension exerted by the yarn on sensor’s loafing cell
((depending on the feeding
tension of the yarn itself), is detected by the electronics of the sensor and converted
by the built-in DSP (Digital Signal Processor) into a digital signal that can be
interpreted both by the TS5.. sensor and by the SMART 200 TSS terminal.
TS5.. devices can be used for yarn quality control (under both static and dynamic
conditions) which, thanks to an innovative patented technique (Tension Smart
Scanning Sensor) combined to the advanced yarn control terminal SMART 200
TSS don't need complex wirings and long installation times, allowing you to
manage up to 200 positions.
The T
S5.. devices are fully programmable for an easy implementation of quality
control of any kind of yarn/application.
As the
TS5.. are parametric devices, it is possible to set freely error percentages on
tension and the duration of anomalies. The TS5. . devices are very easy to use as
they are ready to accommodate a large variety of accessories that make them
suitable to the quality control of any type of yarn.
Function of the TS5.. Sensors
The TS5.. sensors provide the real time control of the yarn running inside the
eyelet and, in case of defect, they either immediately stop the machine position or
activate solenoid-valves, cutters, or other control devices, automatically signalling
which is the first sensor, (
among those connected ), that stopped the position.
The TS5.. sensors have two signaling lights (green LED, red LED) and a “Touch
Light” button.
The “Touch Light” button is used to carry out the automatic sensor numbering and
error reset operations.
During the automatic numbering of the sensors
(flashing green LED), by skimming
the touch light you assign the sensor the number shown on Device Config. Screen
of
SMART 200 TSS terminal.
During on alarm condition (flashing red LED) , by skimming the touch light, you
will reset the position.