btsr IS3W/MTC, Operating Manual

Page: 39 / 89

Operation
SMART 200 MTC -3.25 -
STP-C/P STOP Signal Type in Case of Fault
SETUP CONFIG
STP-C/P
This function allows you to choose the type of signal that will be sent through the
STOP output in case of failure (i.e. yarn broken).
The possible choices are:
Continuous Signal (CONT)
2 seconds Pulse Signal (P2s)
10 seconds Pulse Signal (P10s)
The electrical level of the signal (either high or low) depends on the
configuration chosen for the STP-NCo function.
For more details, please refer to the Interface Specifications (STOP signal)
paragraph.
Once you have selected the STP-xx function from CONFIG menu, press to
have access to the function.
If necessary, press to select the desired option (ST-CONT CONFIG, ST-P2s
CONFIG or ST-P10s CONFIG) .
Press to confirm
The display shows for a few seconds the messages
ST-CONT WAIT and ST-CONT PRG OK or
ST-P2s WAIT and ST-P2s PRG OK or
ST-P10s WAIT and ST-P10s PRG OK to indicate that the function has been
programmed correctly
Press once to return to the CONFIG menu, or twice to return to the Main
Menu.
A
7