© 2004,1996 BRUNO INDEPENDENT LIVING AIDS, INC.®
9
SRE-1540 UL 06-18-2004
INSTALLATION
OVERVIEW OF INSTALLATION
Installation of the
SRE-1540 Electra-Ride™ Stairway Elevator
consists of the following:
*
Determine whether the elevator should be a left- or right-side installation. "Left" or "right"
installation is determined by the side of the stairway on which the rail is installed (viewed
from the bottom of the stairs). THE GEAR RACK WILL BE TOWARD THE CENTER OF
THE STAIRS. Unless specified otherwise, Bruno stairway elevators are set up for
left-side installation when shipped, but can easily be converted to right-side installation.
Instructions for converting the unit for right-hand installation are included later in this manual.
*
Identify and locate lower rail section and bumper bracket assembly.
*
Assemble and tighten the rail joint.
CAUTION: RAILS CANNOT BE MIXED.
CHECK ID NUMBERS STAMPED AT ENDS OF RAILS.
*
Determine the correct length for the rail (using Steps 2 and 4 from the APPLICATION
GUIDE), and cut the rail.
*
Install lower bumper assembly.
*
Position rail on left or right side of stairway using rail clamp assemblies.
*
Install the call/send antenna.
*
Manually mount the carriage on the upper rail.
*
Adjust the carriage angle by loosening the four
angle
adjustment bolts.
*
Install seat assembly and make electrical connections.
*
Secure the footrest.
*
When installing a
right-side
SRE-1540
, follow instructions for
reversing operation
.
*
Remove one motor cover (right-side installation only). Reverse the motor leads and set
the two switches to reverse the direction of the SRE-1540.
* Perform a trial run of the
SRE-1540
to determine final location of rail.
OVERVIEW
OVERVIEW
