© 2004,1996 BRUNO INDEPENDENT LIVING AIDS, INC.®
33
SRE-1540 UL 06-18-2004
CHANGING CONTROLS FROM RIGHT TO LEFT ARMREST
1. Remove the switch housing weldment by removing the Torx head machine screw under
the arm. The trim holding the harness on the backside of the arm slides off.
2. To disconnect the harness under the seat , remove the seat hinge nut.
3. Slide the harness cable guide off.
4. Reinstall the seat hinge nut.
5. Remove the 2 screws from the swivel switch cover, then remove the cover.
6. Unplug the switch harness, and remove the grommet.
7. Slide the grommet onto the other side of the swivel switch cover, and reconnect the
harness.
8. Reassemble the cover using the 2 screws.
9. Remove the seat hinge nut, and install the harness guide on the opposite side.
10. Fasten the switch housing on the left arm. Slide the trim over the harness on the backside
of the arm.
INSTALLATION
CONVERSION TO RIGHT-HAND INSTALLATION -
RESIDENTIAL UNIT
As shipped from the factory, the Electra-Ride
TM
II is set up for left-side installation (
as
viewed from the bottom of the stairs
).
To convert the unit for right-side installation, perform the following operations:
ELECTRICAL
1.
Make sure the circuit breaker switch on the rear of the carriage is in the OFF position.
2.
Remove the back carriage cover and the left side cover.
3.
Set the No. 3 DIP Switch on the 4-ganged dip switch to the
ON
position.
NOTE: It is imperative that the circuit breaker be turned OFF while changing from
left-hand to right-hand installation. Otherwise, the board will not accept the change.
